a/arch/arm/mach-kirkwood/sheevaplug-setup. ![]() Ruled out on the basis that if it fails, you end up with a brick. Change to build_dir/linux-kirkwood/linux-2.6.30.10 and apply the following patch: 1) Automated upgrades using the standard OpenWRT sysupgrade mechanism. Installing FreeSwitch with FusionPBX WebUI to OpenWRT on any other small form-factor device or router is similar. ![]() (This step isn't required, but I recommend it for easier recovery from bad flash writes below.) Use "make kernel_menuconfig" to add built-in SCSI disk, USB EHCI, USB storage, and ext2 filesystem support.ģ. Also select built-in luci and ntpclient packages. Add squashfs in the target images section. The dockstar’s JTAG port uses a 2.0 mm spacing and while it’s good for tight spaces, isn’t exactly ideal when dealing with breadboard jumpers as most breadboards have a 2.5mm spacing and the jumpers have connectors to match. Use "make menuconfig" to configure the build system for a kirkwood target. You need to build your own OpenWrt kernel and root filesystem image, because the Marvell Kirkwood target currently supports only the Sheevaplug, which has a different NAND flash layout. See this page for the serial pinout (and how to open the case) and this page for a picture of where to find the connector.Ģ. Open the case and install a serial cable. Configure OpenWrt so that it can network to the outside world. Thus, the dockstar can be booted directly from an ext2-formated harddisc/usb-stick connected to any of it's USB-ports. Your Dockstar should boot with the USB drive as its root filesystem. ![]() No one has tried to restore the factory firmware yet, so we don't know whether that's possible. It can not only initialize the USB (like all the rest of the hardware) but additionally utilize the USB and also understand the EXT2 filesystem. WARNING: this approach requires you to open the case and install a serial cable, and completely replaces the factory-installed software with OpenWrt. Update: I've consolidated this HOWTO and the following one into a single guide to installing OpenWrt on the Dockstar. oscam svn6388 arm dockstar openwrt webif libusb Distribution tar (442.29 KB) oscam svn6403 arm dockstar openwrt webif libusb Distribution tar (448. This post describes how to install an OpenWrt kernel and rootfs on the internal NAND flash of the Seagate Dockstar so that it will boot into OpenWrt at power-on, with no USB storage device required.
0 Comments
Leave a Reply. |